Canoga-perkins 9140 Four-Port SNMP Managed Fast Ethernet Switch Manual de usuario descargar pdf (Pagina 87)

EdgeAccess SNMP Managed Fast Ethernet Switch

Model 9135/9140

B-3

Verify the following settings:

1. Interface: modem

2. Init Modem At Startup: Yes

3. Modem Init String: ats0 = 1

4. Password Enable: no

5. SLIP Password: (only applicable if password setting is enabled)

6. SLIP IP Address: (specified by the customer)

7. SLIP Subnet Mask: (specified by the customer)

8. SLIP Port Setup: 9600, N, 8, 1

Notice that the parameters have been changed automatically. The 9135 or 9140 is now configured to be

managed via SLIP connection.

B.3 Setting up a Serial Line IP (SLIP) Connection with

Windows NT

Step 1 Verify that a modem is installed in the computer that will be used for the SLIP session. The

modem, which is normally configured when Windows NT is installed, should be listed under

Modems in the Control Panel screen. Move the cursor to Start >> Settings >> Control Panel and

double click on the modem icon. See Figure B-4.

Figure B-4.

Windows NT Control Panel with Modem Icon Selected.

Step 2 Confirm that a modem is installed, as shown in Figure B-4a and that it is correctly configured with

a communications port.

Formatted

Deleted:

Deleted: ™

Deleted: Page of 871

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 98 99

Sin comentarios

Canoga-perkins 9140 Four-Port SNMP Managed Fast Ethernet Switch Manual de usuario Pagina 87