Canoga-perkins 9140 Four-Port SNMP Managed Fast Ethernet Switch Manual de usuario descargar pdf (Pagina 51)

EdgeAccess SNMP Managed Fast Ethernet Switch

Model 9135/9140

5-5

When the Main Menu screen appears, the user may select the appropriate screen to setup, monitor or

change system settings for the Switch configurations. The VT100 program is divided, as seen on the Main

Menu, into eight major areas of functionality:

•

System: IP Addressing, BOOTP Enable, TFTP

•

Switch Configuration: system configuration settings

•

Port Information: individual or group port status information

•

Reports: system reports

• Diagnostics: system diagnostics

•

Restore Defaults: This setting restores all factory defaults with the exception of:

• IP Address

• Gateway IP Address

• Subnet Mask

• SLIP Port settings

•

Restart unit: restarts the unit. After a TFTP firmware upgrade has been completed a restart is

required to change the active bank to that which holds the new upgrade.

Note: Restarting the unit will disrupt the flow of data during the restart sequence.

•

Logout: The user must logout after each session to ensure password integrity. If the user fails to

logout, it may be possible for the next user to access the management program (at the same password

level as the previous user) without entering a password.

5.2.1 System Menu

Figure 5-7. System Menu.

System

•

IP Settings

• Host Table / SNMP

Settings

•

SLIP Port Settings

• Passwords

• Network Name

• Redundancy Setting

• Main Menu

Deleted: Page of 871