
3-6
3.2.3 100BASE-FX Single Mode Module
This is a plug-in module, which contains the 100BASE-FX Single Mode interface Figure 3-6.
The interface components are the following:
•
SC/ST connector
•
Port LEDs
• Tx Transmit (Green)
• Lnk Link (Green)
• Col Collision (Yellow)
• Fdx Half/Full-Duplex (Green)
• Rx Receive (Green)
• Rmtf Remote fault indication (Red) [Managed Units Only]
• Par Partition/Disable (Red)
• Llf Link Loss Forwarding/Enabled (Green) (Disabled on 9140)
•
Connectors: Edge connector to the main board unit
Figure
3-6. 100BASE FX Single Mode Module.
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted
Comentarios a estos manuales