Canoga-perkins 9145E10G Network Interface Device Hardware Manual de usuario descargar pdf (Pagina 46)

Troubleshooting 9145E10G Ethernet Network Interface Device User’s Manual

Fault Conditions

Table 5-2. User, Network, and Multipurpose Port LED Indications

5.2.2 Link Loss Forwarding

When Link Loss Forwarding (LLF) is enabled, a fault on one side of the 9145E10G propagates to

the other side to notify that device and stops signal transmission (see Figure 5-2). Set the LLF

propagation to User to Network, Network to User, or both directions. Set this in the User Interface

at the Functional Configuration screen (reference

6913367, 9145E10G NID Software Users Man-

ual).

LED Name State Condition

SPD

Off

10BaseT (UTP only)

Auto

Connector Not Selected

Green 1000BaseT or 1000Base-FX for SFP port

Amber

100BaseT or 100Base-FX for SFP port

System Test

Red Remote Fault (SFP Only)

Blinking Red Invalid/Unsupported SFP installed (SFP Only)

Slow Blinking Green* Connector Selected with No Link

L/A

Off

No link

No transmit or receive activity

Green Link on with full duplex

Blinking Green Transmission or receiving activity with full duplex

Amber

System test

Link up with half duplex

Blinking Amber Transmission or receiving activity with half duplex

Red

Port Disabled

LLF

Blinking Red No Link, but transmitting OAM packets in unidirectional mode

* Slow Blinking Green means the LED toggles between OFF and GREEN approximately once per

second.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 54 55

Sin comentarios

Canoga-perkins 9145E10G Network Interface Device Hardware Manual de usuario Pagina 46