Canoga-perkins 9145E10G Network Interface Device Hardware Manual de usuario descargar pdf (Pagina 41)

Operation 9145E10G Ethernet Network Interface Device User’s Manual

Power-Up and Front Panel Functions

4.1.2 XFP, SFP and UTP Port Status LEDS

The Speed (SPD) and Link/Activity (L/A) LEDs are located above the XFP, SFP and UTP Ports of

each port section (see Figure 4-1). See Table 4-2 to determine the current condition of these

ports.

Table 4-2. User and Network Port LED Indicators

LED Name State Condition

SPD

Off Port Disabled

Green 10GBase Full

Amber System Test

Red Remote Fault

Blinking Red Invalid/Unsupported XFP installed

Slow Blinking Green* Port Enabled but No Link

L/A

Off

No link

No transmit or receive activity

Green Link on with full duplex

Blinking Green Transmission or receiving activity with full duplex

Amber System test

Red

Port Disabled

LLF

Blinking Red No Link, but transmitting OAM packets in unidirectional mode

* Slow Blinking Green means the LED toggles between OFF and GREEN approximately once per

second.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 54 55

Sin comentarios

Canoga-perkins 9145E10G Network Interface Device Hardware Manual de usuario Pagina 41