Canoga-perkins 9145E10G Network Interface Device Hardware Manual de usuario descargar pdf (Pagina 40)

9145E10G Ethernet Network Interface Device User’s Manual Operation

Power-Up and Front Panel Functions

panel LED, located directly below the L/A LED, indicates the speed of the transmissions. See

Table 4-1 to determine the 9145E10G status.

Table 4-1. Power, Status, and Ethernet Management LED Indications

LED Name State Condition

POWER

Off Power is off

Green Power is on

Red

One of the board supply voltages has exceeded a

threshold value

STATUS

Off No Power

Green Normal operation

Amber System self-test in progress

Blinking Amber System is booting

Red

One of the board supply voltages has exceeded a

threshold value

L/A

Off

No link

No transmit or receive activity

Green Link on with full duplex

Blinking Green Transmission or receiving activity with full duplex

Amber

System Booting

Link on with half duplex

Blinking Amber Transmission or receiving activity with half duplex

SPD

Off Port Disabled

Green 10GBASE full

Amber System Test

Red Remote Fault

Blinking Red Invalid/Unsupported XFP installed

Slow Blinking Green* Port Enabled but No Link

* Slow Blinking Green means LED toggles between OFF and GREEN approximately once per

second.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 54 55

Sin comentarios

Canoga-perkins 9145E10G Network Interface Device Hardware Manual de usuario Pagina 40