Canoga-perkins CanogaOS Configuration Guide Manual de usuario descargar pdf (Pagina 278)

CanogaOS Configuration Guide

Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 278 of 350

DUT(config-ip-acl)# exit

DUT(config)# ip access-list ip-acl2

DUT(config-ip-acl)# permit any host 11.3.1.1 any

DUT(config-ip-acl)# exit

DUT(config)# qos aggregate-policer transmit1 color-blind cir 48000 cbs 8000 ebs

10000 drop-color red

DUT(config)# class-map cmap1

DUT(config-cmap)# match access-group ip-acl1

DUT(config-cmap)# exit

DUT(config)# class-map map cmap2

DUT(config-cmap)# match access-group ip-acl2

DUT(config-cmap)# exit

DUT(config)# policy-map aggflow1

DUT(config-pmap)# class-map cmap1

DUT(config-pmap-c)# policer-aggregate transmit1

DUT(config-pmap-c)# exit

DUT(config-pmap)# class-map cmap2

DUT(config-pmap-c)# set priority 56 color green

DUT(config-pmap-c)# police-aggregate transmit1

DUT(config-pmap-c)# exit

DUT(config-pmap)# exit

DUT(config)# interface eth-0-1

DUT(config-if)# service-policy input aggflow1

DUT(config-if)# exit

Configure QoS Mapping tables

CoS-Priority-Color Map

The following shows modifying a CoS-Priority-Color map. This map is used to generate an

internal priority color value from CoS during classification; this value determines the QoS action

in the DUT, such as selecting one of the eight egress queues, etc.

1. configure terminal.

2. qos map cos-pri-color cos <0-7> to PRIORITY COLOR to modify the

CoS-Priority-Color Map.

PRIORITY = priority value, range is 0-63.

COLOR = color values, red, yellow or green

The following example shows mapping cos 1 to priority 63 color green

DUT# configure terminal

1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 349 350

Sin comentarios

Canoga-perkins CanogaOS Configuration Guide Manual de usuario Pagina 278