Canoga-perkins CanogaOS Configuration Guide Manual de usuario descargar pdf (Pagina 256)

CanogaOS Configuration Guide

Proprietary & Confidential Canoga Perkins Metro Ethernet Switches Page 256 of 350

DUT1(config-if)# no switchport Configure the port to layer

3 port.

DUT1(config-if)# enable-ldp Configure Interface for

LDP

DUT1(config-if)# ip address 2.2.2.1/24 Create IP address on the

port.

DUT1(config-if)# exit Exit the Interface mode.

DUT1(config)#interface loopback 0 Enter the Interface mode.

• loopback0—Specify the

loopback interface name.

DUT1(config-if)#ip address 10.10.10.10/32 Create loopback addresses

on both PE routers. Use a

/32 host route for the

loopback address.

DUT1(config-if)#exit Exit the Interface mode.

DUT1(config)#ip vrf vpn1 Configure a VPN routing

and forwarding(VRF)

routing table

DUT1(config-vrf)#rd 1:100 Assign a route

distinguisher (RD) for the

VRF.

DUT1(config-vrf)#route-target both 1:100 Add a list of import and

export route-target

extended communities to

the VRF.

DUT1(config-vrf)#exit Exit VPN routing and

forwarding(VRF) routing

table.

DUT1(config)# router ldp Enter the router-ldp mode.

DUT1(config-router)# targeted-peer

11.11.11.11

Configure Targeted Peer in

LDP.

DUT1(config-router)# transport-address

10.10.10.10

Configure Transport

Address in LDP.

DUT1(config-router)# exit Exit the router-ldp mode.

DUT1(config)#interface eth-0-1 Enter the Interface mode.

• eth-0-1—Specify the

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 349 350

Sin comentarios

Canoga-perkins CanogaOS Configuration Guide Manual de usuario Pagina 256