Canoga-perkins 9175 Configuration Guide Manual de usuario Pagina 172

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 280
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 171
CanogaOS Configuration Guide
27-1
27 Configuring BGP/MPLS VPN
27.1 Topology
Figure 27-1: BGP/MPLS VPN
27.2 Configuration steps
27.2.1 CE1 (DUT1)
DUT#configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-9 Specify the interface (eth-0-9)to be configured and enter the
Interface mode.
DUT (config-if)#no shutdown Enable the interface.
DUT(config-if) # no switchport Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 2.2.2.3/24 Configure IP address to 2.2.2.3/24.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)#interface eth-0-22 Specify the interface (eth-0-22)to be configured and enter the
Interface mode.
DUT (config-if)#no shutdown Enable the interface.
DUT(config-if) # no switchport Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 8.8.8.2/24 Configure IP address to 8.8.8.2/24.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)# ip route 5.5.5.0/24 2.2.2.2 Add a static route 5.5.5.0/24 with nexthop 2.2.2.2
AS
1
CE1 PE1 PE2 CE2
e-0-22 e-0-9 e-0-9 e-0-20 IBGP e-0-20 e-0-9 e-0-9 e-0-1
eth62
8.8.8.2 2.2.2.3 2.2.2.2 1.1.1.3 1.1.1.2 5.5.5.5 5.5.5.3 9.9.9.8
9993
VPN 100 VPN 100
Vista de pagina 171
1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 279 280

Comentarios a estos manuales

Sin comentarios