Canoga-perkins 9175 Configuration Guide Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 280
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
CanogaOS Configuration Guide
1-2
1.2.2 Configurations
Bridge 1
DUT#configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-1 Enter the interface mode.
DUT(config-if)#speed 100 Set interface eth-0-1 speed to 100M.
DUT(config-if)#interface eth-0-2 Enter the interface eth-0-2.
DUT(config-if)#speed 1000 Set interface eth-0-2 speed to 1000M.
DUT(config-if)#interface eth-0-3 Enter the interface eth-0-3.
DUT(config-if)#speed auto Set interface eth-0-3 speed to auto negotiation.
DUT(config)#end Exit to exec mode.
DUT#show interface status Display interface speed.
1.2.3 Validation Commands
Bridge 1
DUT#show interface status
Port Status Duplex Speed Mode Type
------------------------------------------------------------
eth-0-1 up a-full 100 access 1000BASE_T
eth-0-2 up a-full 1000 access 1000BASE_T
eth-0-3 up a-full a-1000 access 1000BASE_T
1.3 Configuring Interface Duplex
1.3.1 Topology
Figure 1-3: Interface Duplex
1.3.2 Configurations
Bridge 1
DUT#configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-1 Enter the interface mode.
DUT(config-if)#duplex full Set interface eth-0-1 duplex to full.
DUT(config-if)#interface eth-0-2 Enter the interface eth-0-2.
DUT(config-if)#duplex half Set interface eth-0-2 duplex to half.
DUT(config)#interface eth-0-3 Enter the interface eth-0-3.
DUT(config-if)#duplex auto Set interface eth-0-3 duplex to auto negotiation.
DUT(config-if)#end Exit to exec mode.
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 279 280

Comentarios a estos manuales

Sin comentarios