Canoga-perkins 9155 Network Interface Device Manual de usuario descargar pdf (Pagina 40)

Table 12. Latency/Jitter Test Definitions

Parameter Description

1. Test IP Address Where the 9155 sends the packets

2. Test Duration How long to run the test, in minutes and seconds; 0 means don't stop

3. Test Packets per second How many packets to send each second

4/5. Min/Max Test Packet Size Set the size limits for each packet, from 40 to 1472 bytes

6. Test Packet Timeout How long to wait for a test packet to return

4.9.2 PING

Use the PING Generation screen to test the connection to a specific IP address. See Figure 40. To

use PING to check a connection, follow these steps:

1. From the Main Menu, type

5, "Diagnostics," and press <Enter>.

2. At the PING menu prompt, set the PING parameters, and press <Enter>.

"PING response received..." indicates a good connection;

"TIMEOUT: Unable to reach [IP address]..." indicates a faulty connection.

3. To stop the PING , press <Esc>.

PING

1. Ping Address : 0.0.0.0

2. Ping Count : 0

3. Ping Size : 0

4. Start Pinging

5. Main Menu

Figure 40. PING Generation Screen

9155 Network Interface Device

4-24

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Sin comentarios

Canoga-perkins 9155 Network Interface Device Manual de usuario Pagina 40