Canoga-perkins 9161 Network Interface Device Manual de usuario descargar pdf (Pagina 15)

Hardware Installation 9161 Ethernet Network Interface Device User’s Manual

Power-Up, Hardware Functions, and LEDs

Connect the Optical Fiber cables to the XFP modules as follows:

1. Plug in the optical cable connectors with proper Tx to Rx or Rx to Tx orientation.

2. Ensure cable locks in place.

3. Label each cable and connector with the signal name and direction.

Canoga Perkins recommends that you determine and record link attenuation and transmission

power before starting normal link traffic. The attenuation factor and transmission power identify

potential problems with links near the lower limit of receiver limitations.

For details on link attenuation and transmission power, reference Chapter 4, Maintenance and

Troubleshooting.

2.2 Power-Up, Hardware Functions, and LEDs

During the initial power-up sequence, all LEDs light amber. When start-up is complete, the setup

and installation are correct, and data is transmitting normally across the link, the Rx and Tx LEDs

for both ports light green or blink green when transmiting or receiving data.

The LEDs show the system and port conditions. The P1, P2, Fans, and Management LEDs

show the management conditions; see Table 2-1. Table 2-2 lists all possible LEDs. For details

about the LEDs, see your interface module and Tables 2-1 and 2-2.

Table 2-1. 9161 Management LEDs

LED FUNCTION COLOR STATUS DESCRIPTION

transmit status

10G-1/10G-2

amber on system self-test

green blinking normal operation

red

port disabled; may be due to link loss for-

warding (LLF)

off no power/power supply not installed

Rx receive status

amber on system self-test

green on link established

green blinking receiving activity

red

on receiving remote fault

off no link

NET not supported

amber on system self-test

green on normal operation

MGR management status

green blinking

Ethernet packets are being sent to the CPU

for processing

amber on system self test/over temp

amber blinking

system self test/over temp with manage-

ment traffic

red

on diagnostic failure or CPU failure

off power off

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Comentarios a estos manuales

Sin comentarios

Canoga-perkins 9161 Network Interface Device Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Canoga-perkins 9161 Network Interface Device