Canoga-perkins 1020 Standalone Enclosure Manual de usuario descargar pdf (Pagina 3)

EdgeAccess Model 1020

Model 1020 Standalone Enclosure User Manual

The Model 1020 standalone enclosure, shown in Figure 1, supports one 2U-sized module that is

managed through either SNMP or Sideband Management Control (SBMC).

Figure 1. Model 1020 Standalone Enclosure

The front provides three switches, three LEDs, two connectors, and a slot for a managed module. The

back includes an AC power cord socket. The AC power supply provides +5 VDC to the module.

Switch Setting Selects

MDM/TRM for EIA-232 port MDM DTE terminal for SLIP

TRM DCE terminal for VT100

F1/NRM/F2, typically for Loopback for the module F1 Local loopback, typically

Note: Set to NRM except to isolate a fault.

NRM Normal operation

F2 Remote loopback, typically

HDX/FDX for 10BASE-T port HDX Half duplex

FDX Full duplex

Note: If the link partner is set to auto-negotiation, the link uses 10M and follows the HDX/FDX

switch setting for this port; otherwise, set this switch to match the other switch on the link.

LED State Definition

PWR Off No power

Green Power is on

Tx for 10BASE-T port Off No transmission

Green blinking Transmission activity

LNK/Rx for 10BASE-T port Off No link

Green Link is established at full duplex

Amber Link is established at half duplex

Blinking Data is received

1 2 3 4 5 6

Sin comentarios

Canoga-perkins 1020 Standalone Enclosure Manual de usuario Pagina 3